Local Shutter InstallersSeasons · Season
Timers and the clock change
Updated
A dusk routine that is fixed to an old clock will close at the wrong hour after the clocks move, or fail to track the season. Check the timer on the Sunday the clocks change.
When the curtain has to be down
It is a tiny chore and it is the difference between a shutter that is used and one that is resented.
A size you can argue with
The worked opening for Timers and the clock change is 3.2 m wide by 1.5 m high, 4.8 square metres of glass. This figure puts 570 watts per square metre on the pane and uses a g-value of 0.63, about 1724 watts into the room if the curtain is up. An opaque external shutter, taken as stopping 80 percent of that gain while it is fully down, leaves about 345 watts and keeps about 1379 watts out. That is a noon figure for comparison. An internal blind does not get the same reduction. For Timers and the clock change, use the noon figure to compare two openings on the same house, then let a measured survey replace the figure.
An internal blind does not get that reduction, because the energy has already crossed the glass.
The night cover
Winter figure for Timers and the clock change: glass at 1.2 W/m2K, 4.8 square metres, a 12 degree inside-outside gap and eight night hours. The bare pane is about 0.55 kWh a night on that crude sum. A closed shutter cutting about 18 percent of the flow leaves 0.45 kWh and saves about 0.10 kWh a night, only while it is down. Open it when you want winter sun.
A bad reason to proceed
Stop Timers and the clock change if the only place for the box is a listed street front and nobody has written advice from the council. A photograph is not a manufacturing size.
Leicester is only a setting for Timers and the clock change. The streets there are not the product.
How to use the figure
The 3.2 by 1.5 metre opening inside Timers and the clock change is there so a quote has something to disagree with. If the tape gives a different size, the tape wins.
The example drive is a belt, and the illustration is £3,415. A belt, a wired motor and a solar motor can share a curtain and still be different jobs. Compare those lines, not a single bold total.
What the survey still has to write down
For Timers and the clock change, ask where the box lands, what colour reference will be ordered, and how the curtain opens when the motor is dead. Those three answers move the job more than a rounded price.
Leave the lantern, the side light and the next elevation off the order unless they are drawn. Timers and the clock change covers one kind of opening. The house may have three.
When I would not order yet
Timers and the clock change should wait if the opening is an escape door with no way to raise a dead motor, or if the front is the elevation a conservation area was drawn to protect.
A photograph is not a manufacturing size. Two quotes for Timers and the clock change only compare when the slat, the box and the drive are the same kind of thing.
Questions worth asking the fitter
Is the price on this page a quote?
No. £3,415 illustrates Timers and the clock change for a 3.2 by 1.5 metre opening with a belt, at September 2026 rates. Your survey replaces it.
Does the shutter cover every pane?
It covers the opening it is built for. Here that example is 4.8 square metres. A roof lantern, a side light or the next elevation is another line.
What if planning is unclear?
Do not pay the factory for Timers and the clock change until a listed building, a conservation front, a flat or a shopfront has a written answer. Ordinary rear walls on houses are sometimes simpler.
What should two quotes share?
The same openings, the same slat type, and the same drive. Timers and the clock change uses a belt in the example so you can see how much the motor choice moves £3,415.